500 Каталог KYOCERA 2016 Металлорежущий инструмент для токарной обработки на станках Стр.H8

Каталог KYOCERA 2016 Токарные резцы с пластинами Стр. H8 0500 ENG Lab2u

CUT-OFF CUT-OFF TOOLHOLDERS (SMALL DIAMETER) KTKF (For Small Diameter Cut-Off) Fig. 1 Right-hand Shown Right-hand Insert for Right-hand Toolholder (Goose-neck Holder) KTKFL52-12JX shown above Fig.2 Left-hand Shown Left-hand Insert for Left-hand Toolholder Toolholder Dimensions Dimension T shows the distance from the toolholder to the cutting edge. See Page ( H6-H7 for actual cutting diameter. Note Cutting diameter of -12 type toolholder (0Dmax) depends on the insert grooving width. How to Use 1) When using main spindle only Workpiece maximum 0D1 (Fig.1 )=0Dmax Even if the cutting edge runs beyond the center line, the insert does not contact the workpiece, since the workpiece falls off. (The clearance between the insert and the workpiece is 0.008") Recommended Cutting Conditions H32 Main Spindle Fig.1 Fig.2 (When the edge is at the center) (When the edge is 0.008"beyond the center) - O