489 Каталог KYOCERA 2016 Инструмент режущий станочный Пластины Резцы Фрезы Сверла Стр.H25

Каталог KYOCERA 2016 Режущий инструмент для станков Стр. H25 0489 Lab2u

Cut-Off Inserts TKN/TK& Insert Handed Insert shows Right-hand Classification of usage Continuous-Light Interruption / 1st Choice Continuous-Light Interruption / 2nd Choice Continuous / 1st Choice Continuous / 2nd Choice Description Carbon steel / Alloy steel Stainless Steel Cast Iron Non-ferrous Metals Dimension (mm) Размеры инструмента указаны в мм W re Angle o Cermet O 6 O in CC C MEGACOAT NANO in 3 in DC P PVD Coated Carbide O 6 6 OC P O 3 o oc P Carbide e r d e lh go ao P T o le t b .f a ec p A TKN 1.6 0.15 2 2.2 0.20 2.4 2.4 0.20 3.1 0.25 4.1 0.30 4.8 4.8 0.30 5.1 0.30 6.4 0.35 0.40 9 9.6 0.45 H26 H28 H26 TKN 1.6-P 0.20 2-P 2.2 0.20 H26 H28 3-P 3.1 0.25 TK& 1.6 0.15 2 2.2 0.20 2.4 2.4 0.20 o 3.1 0.25 4.1 0.30 5 5.1 0.30 H26 H28 TK& 1.6-P 0.20 2-P 2.2 0.20 o 3-P 3.1 0.25 Cut-Off Tools Recommended Cutting ConditionsO H29 Cutting Range Chipbreaker Advantage General Cut-Off Standard (Without Indication) General cut-off type for feed rates over 0.1mm/rev Superior chip evacuation Low feed Cut-Off P & Chipbreaker specially designed for low feed machining on automatic lathes, etc. Chips are controlled at feed rate 0.03 0.08mm/rev Inserts Edge Prep. Edge Prep. Std. Chipbreaker P-Chipbreaker Chamfer + Honed y TN90 CR9025 / PR660 Sharp Edge k PR1535 PR930 / KW10 R honed TN620 / TN90 / CR9025 / PR1535 PR660 / PR930 / KW10 Sharp Edge Spec. can reduce cutting force by 40% less than that of chamfer edge. Set Up (TKN / TK&) 1. Tap the insert lightly with a plastic hammer to push it into the extent that it can not be removed by hand. (Fig.1) (Pull it to the point where it does not fall out when picked up lightly with fingers) 2. Remove the insert with the supplied wrench. (Fig.2) Std. Item O Check Availability Fig.2 How to detach inserts 1 Inserts are sold in 10 piece boxes. H25 p M 0 3 4 5 6 8 R L R L L R L R L R L R L e 3 4 e Cut-off