1446 Каталог KENNAMETAL 2013 Инструментальная оснастка для металлорежущих станков Стр.M46

Каталог KENNAMETAL 2013 Инструментальная оснастка Стр. M46 1446 Lab2u

Technical Information Technical Information KM Application Data Kennametal Operating Conditions KM63TS and KM63XMZ Metric IMPORTANT Information shown on the following charts was developed exclusively for use with KM tooling in static conditions. Do not use for any other tooling system because the results will not apply. To account for cutting force fluctuations in dynamic conditions, a reduction of 20-30% should be applied to the loads shown in charts. Chart 7 F and L1 Dimensions (mm) vs. Tangential Loads (N) for KM63TS and KM63XMZ F (mm) Chart 8 Depth of Cut (mm) and Feed Rate (mm/rev) vs. Tangential Forces (N) for KM63TS and KM63XMZ (mm) feed rate (mm/rev) M46 n, KENNAMETAL