1445 Каталог KENNAMETAL 2013 Инструментальная оснастка для металлорежущих станков Стр.M45

Каталог KENNAMETAL 2013 Инструментальная оснастка Стр. M45 1445 Lab2u

Kennametal Technical Information KM Application Data Operating Conditions KM50TS Inch IMPORTANT Information shown on the following charts was developed exclusively for use with KM tooling in static conditions. Do not use for any other tooling system because the results will not apply. To account for cutting force fluctuations in dynamic conditions, a reduction of 20-30% should be applied to the loads shown in charts. Chart 5 F and L1 Dimensions (inch) vs. Tangential Loads (lbs) for KM50TS F (inch) L1 (inch) Chart 6 Depth of Cut (inch) and Feed Rate (IPR) vs. Tangential Forces (lbs) for KM50TS (inch) feed rate (IPR) n, KENNAMETAL M45 Technical Information