1055 Каталог WIDIA 2011 Инструментальная оснастка для металлорежущих станков Стр.K19

Каталог WIDIA 2011 Инструментальная оснастка Стр. K19 1055 ENG Lab2u

WIDIA Technical Information KM Tooling Assembly/Disassembly Instructions Assembly/Retiming Procedure (continued) 7. Thread the torque screw/lockrod assembly outward one full turn (360°), making sure the raised key faces outward. Place a KM cutting unit into the clamping unit. It should drop into the taper easily. If it does not, repeat Step 7. 11. Reinstall the socket-head cap screws that retain the bump-off pin (see Frame 8). Check for proper operation of the unit by pushing down on the end of the bump-off pin with your finger while tightening and loosening the torque screw through its full travel. You should feel the bump-off pin move in and out as the direction of the torque screw changes. 8. Insert the bump-off pin without its O-ring into the bore, being certain the angled surface of the bump-off pin will ride on the angled surface of the lockrod (see Frame 7). 9. When the bump-off pin is properly seated, its largest diameter should be below the end of the canister it should not rotate. The pin is rotationally restrained by the lockrod key, in the bump-off pin keyway. 12. As a final check, rotate the torque screw outward until it stops. Install a KM cutting unit and tighten the torque screw to the proper torque required for locking. Ensure that there is no air gap between the locking faces of the cutting unit and the clamping unit. Loosen the torque screw. Initially, resistance will be felt while loosening the screw, and again when bumping off the tool from the taper. Only use light force to loosen the screw after the tool has been bumped off. Do not force the torque screw loose after tool bump-off or damage may result. Remove the cutting unit and install protective plastic or steel plug. 10. If all is correct, remove the bump-off pin, install its O-ring, lightly coat with grease paying particular attention to the slot, and reinstall into the bore. WIDIA K19 Technical Information