Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS

Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS

Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS _ VCXB Рекомендуемые режимы резания при обработке на станке RECOMMENDED CUTTING CONDITIONS Work material Alloy steel, Tool steel, Pre-hardened steel AISI H13, AISI W1-10, AISI P21 Hardened steel (45 55HRC) AISI H13 R RE (mm Taper angle one side BHTA2 Neck length LU (m De ioitut Revduliin (mir4 Feed rata (mm/min) Revdution (miir1) Feed rate (mmMiin ap (mm i (mm R0.5 1° 16 0.02 0.1 22000 530 12000 230 1“ 21 0.01 1° 26 0.01 1.5° 23 0.02 3° 42 0.05 5° 23 0.05 R1 1" 21 0.05 0.2 18000 570 10000 260 1“ 31 0.04 1° 41 0.03 1.5° 23 0.1 3° 41 0.1 5° 23 0.1 R2 1° 36 0.2 0.8 14000 670 6000 200 1° 46 0.15 1° 60 0.1 1.5° 49 0.2 3" 28 0.2 R3 1° 51 0.3 1.2 10000 840 5000 220 1° 65 0.2 1° 92 0.1 1.5° 53 0.3 3' 34 0.3 R4 1.5° 55 0.4 1.6 8000 840 4000 270 3' 36 0.4 R5 1“ 70 0.4 2 6000 840 3000 310 1° 100 0.3 1.5° 59 0.5 3' 40 0.5 R6 1" 70 0.6 2.4 5000 900 2500 340 1° 100 0.4 1.5° 83 0.6 3° 63 0.6 ae ap If the depth of cut is shallow, the revolution and feed rate can be increased. If the rigidity of the machine or the work materials installation is very low, or chattering and noise are generated, reduce the revolution and feed rate proportionately. Mitsubishi Materials 961 Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS _ TAPER RADIUS BALL SQUARE carbide