476 Каталог HOFFMANN GROUP 2016 Станочный режущий и вспомогательный инструмент Вер. 47 Стр.476

Каталог HOFFMANN GROUP 2016 Режущий инструмент и оснастка Стр. 476 0476 ENG Lab2u

Hoffmann Group 47 III POWER CARD 4asat M T-slot cutter for SP.T 0603.. / 09T3.. /1204. End mill with clamping face and internal coolant supply. Deeply recessed at the cutting area to allow working in very deep slots. Anti-corrosion surface treatment. Application: For slots to DIN 650. Note: Coolant feed via the internal coolant supply is preferable in order to achieve optimum chip clearance. 0D/Zt„ - 218300 number of effective inserts m Number of inserts Slot depth 0d, L, L. 0DS h6 suitable indexable insert Pack of insert screws T-slot cutter 3p mm Weldon shank mm 21/1 266.31 1 2 9 11 26 76 16 SP.T 060304 219840 (8IP; 1,2 Nm) 25/2 315.81 2 4 11 13 31 82 16 5P.T 060304 219840 (8IP; 1,2 Nm) 32/2 341.55 2 4 14 17 38 88 20 SP.T 09T308 219841 (15IP; 3.0 Nm) 40/2 365.31 2 4 17 21 50 108 25 SP.T 09T308 219841 (15IP; 3.0 Nm) 50/2 417.78 2 4 22 27 56 120 32 SP.T 120408 219848 (20IP; 5.5 Nm) /bGaiant Milling inserts SP.T 0603.. / 09T3.. /1204.. for T-slot cutter No. 218300 Suitable for/ v( m/min Alu plastics Alu cast >10%5i dc < 500 N DC < 750 N DC < 900 N DC < 1100 N X <1400 N X <55 HRC X < 60 HRC X <65 HRC X <67 HRC X <70 HRC INOX <900 N INOX >900 N Ti >850N 55(6) Uni 6 i ISO code nri Mr- hn P H K HU7815 750 700 600 450 O HB720 220 200 180 140 120 180 160 O Type ALU UNI o SPGT 060304 HU7815 9.36 - It -218320 HB720 - 8.91 It -218325 HU7815 10.04 - It -218340 HB720 - 9.54 It -218345 HU7815 11.16 - It -218360 HB720 - 10.62 It fz (218305,21 8320 mm 0.12 0.09 fz (218325,21 8340) mm 0.14 0.11 f, (218345,218360) mm 0.15 0.12 Application instructions for T-slot cutter No. 218300 At a decreasing engagement width a, / D the cutting speed v( must be reduced. The feed rate per cutter f, must be corrected using the factor X. 1. a,/D 100% 50% 20% 10% v, 70% 80% 90% 100% X 1 1 1,3 1,5 2. 3. 0 D 476