41 Каталог KYOCERA 2017 Инструмент сборный и монолитный для станков Стр.B12

Каталог KYOCERA 2017 Инструмент режущий Стр. B12 0041 Lab2u

Chipbreaker Selection (Positive Inserts) Steel Q Molded Chipbreaker Стружколом сменной пластины Range Name CF GF GQ SK CK WP GK PP Design £ 20' 0.05 Advantages Available for minute ap (0.02 to 0.2mm) finishing. Chips fragmented in small pieces in machining of small ap. Enables machining over a wide range of conditions by using the optimum chipbreaker width according to the cutting depth. Sharp cutting performance due to Large rake angle. Large dot to the corner edge improved chip control in a wide feed rate range. Good cutting performance. Applicable without hand for two direction machining on automatic lathe. Wiper insert. Good surface finish and good chip control at high feed machining.Reduces surface finish galling. Good chip evacuation at wide range by breaker dot and wide chip pocket. 1st. Recommendation at steel finishing.Stable chip control in a wide feed rate range.Stable tool life due with sharpness and improved strength, Applicable Chipbreaker Стружколом сменной пластины Range (ap indicates radius) (Steel) (Steel) 5 4 E £ 3 O. co 2 1 SK Finishing f (mm/rev) 0.05 0.1 0.15 0.2 f (mm/rev) (Steel / Edge Length=11) Cutting Range Name DP GP VF HQ G Design 0.15 (Steel / Edge Length=07, 11) Advantages Consistent chip breaking performance for finishing. Good chip control. Good chip control for varied ap such as copying and undercutting. General purpose chipbreaker for medium machining. Chipbreaker Стружколом сменной пластины for short chips at medium machining. Strong edge chipbreaker for medium machining range. GK f (mm/rev) (Steel / Edge Length=16) 0.1 0.2 0.3 0.4 f (mm/rev) 0.1 0.2 0.3 f (mm/rev) 0.1 0.2 0.3 f (mm/rev) (Steel / Edge Length=11) Standard (RP> GP f (mm/rev) 0.1 0.2 0.3 0.4 f (mm/rev) 3 CK 3 3 G 2 HQ VF B12