73 Каталог KYOCERA 2016 Фрезы со сменными режущими пластинами для металлообработки Стр.C21

Каталог KYOCERA 2016 Инструмент фрезерный с СРП по металлу Стр. C21 0073 ENG Lab2u

MSE45-SF SEEN Wiper Insert Wiper Insert Features By installing one wiper insert on the cutter that also has a standard inserts attached, the surface roughness can be improved. The edge geometry of the wiper insert is an arc style and overhang is slightly prominent to the axis direction when cutter is installed. Finishing with a wiper insert enables better surface quality. Recommended Cutting Conditions 1) Vc, fz should be within recommended cutting conditions 2) D.O.C. < 0.0197" Mounting Wiper Insert 1) Install only one wiper insert along with standard inserts. 2) As only one edge of the wiper insert is used, make sure insert arrow mark “ i ” faces the workpiece cutting surface. 3) Check overhang amount of wiper insert using MSE45-SF type so that you can obtain stable surface roughness. Setup Overhang for Wiper Edge 1) Please adjust wiper insert overhang within 0.0012" to 0.0039" from the largest overhang of the standard inserts. If overhang is larger than this, the life of the wiper insert will be lower. 2) 0.0020" overhang is recommended for the wiper insert. x5 Edges + x1 Edge KW10 H KPD001 Arrow side is wiper edge Example when Finishing Aluminum with 0125mm... Lower Costs & Good Surface Finish Case Studies For Aluminum (5052) 3.0 CC No Wiper Insert Attaching SEEN Wiper Insert ( Overhang +0.002" ) For Steel (1049) 3.0 CC No Wiper Insert” Attaching SEEN Wiper Insert ( Overhang +0.002” ) Cutting Conditions MSE45100R-6T-SF Vc = 980 sfm D.O.C. = 0.0079" fz = 0.0079 ipt Wet No Wiper Insert SEKN42AFFN (KW10) 6 Inserts With Wiper Insert SEKN42AFFN (KW10) 5 Inserts SEEN42AFFR-W (KPD001) 1 Insert Cutting Conditions MSE45100R-6T-SF Vc = 660 sfm D.O.C. = 0.0079" fz = 0.0039 ipt Dry No Wiper Insert SEKN42AFTN (TN100M) 6 Inserts With Wiper Insert SEKN42AFTN (TN100M) 5 Inserts SEEN42AFTR-W (TN100M) 1 Insert _i Example of attaching wiper insert No. Insert Edge Fluctuation Standard -0.006mm Standard -0.011mm Standard -0.015mm Standard Omm Standard -0.008mm With Wiper Edge +0.03mm +0.10mm Attach Insert Facing the Workpiece KMnrFRrl 091 I\3ULlI\Q I GRADES LINEUP/INSERTS 45°/70°LEAD 75° LEAD 90° LEAD HIGH FEED MULTI-FUNCTION SLOTMILLS RADIUS/BALL-NOSE OTHER APPUCATIONS TOOLHOLDING SPAREPARTS TECHNICAL INDEX