72 Каталог KYOCERA 2016 Фрезы со сменными режущими пластинами для металлообработки Стр.C20

Каталог KYOCERA 2016 Инструмент фрезерный с СРП по металлу Стр. C20 0072 ENG Lab2u

45° / 70° LEAD MSE45-SF How to Adjust Cutting Edge Height Screw Names MSE45-SF MTE90-SF Adjustable Height for the Cutting Edge For model MSE45-SF: Approx. 0.02mm For model MTE90-SF: Approx. 0.05mm (The difference in adjustable height varies because of the difference in corner angles.) For the explanations below, refer to the screw names indicated above. 1) Partial Adjustment of the Adjustment Screw 2) Partial Tightening of the Clamp Screw and Cartridge Screw Loosen the edge adjustment screw Tighten as much as the edge adjustment screw is tensioned Partial tighten the cartridge screw. Partial tighten the clamp screw. n Tightening :r i Loosening Perform work with all inserts attached in their correct positions. Notes) Partial tightening: Tighten the adjustment screw only partially, so that further adjustment is still possible. 3) Measuring the Cutting Edge Fluctuation Example: Measuring the Front Cutting Edge Fluctuation No. Measurement Results Results Edge Fluctuation 0.263mm -0.006mm 0.258mm -0.011mm 0.254mm -0.015mm 0.269mm Max. 0mm 0.261mm -0.008mm 0.250mm Min. -0.019mm Current fluctuation:19pm (Number are not indicated on Milling Cutter) With each of these screws partialy tightened: cartridge screw, clamp screw, adjustment screw, measure the cutting edge fluctuation. 4) Correcting the Fluctuation Based on the measurement results, correct the fluctuation. 5) Firm Tightening of the Cartridge and Insert Fully tighten the cartridge screw. Using the measured amount of fluctuation, adjust so that the fluctuation is corrected at the highest corner of the cutting edge, then fully tighten the adjusting screw. C2d