1440 Каталог KENNAMETAL 2013 Инструментальная оснастка для металлорежущих станков Стр.M40

Каталог KENNAMETAL 2013 Инструментальная оснастка Стр. M40 1440 Lab2u

Technical Information Technical Information KM Application Data Kennametal Operating Conditions KM32TS Metric IMPORTANT Information shown on the following charts was developed exclusively for use with KM tooling in static conditions. Do not use for any other tooling system because the results will not apply. To account for cutting force fluctuations in dynamic conditions, a reduction of 20-30% should be applied to the loads shown in charts. Chart 1 F (mm) Chart 2 doc F and L1 Dimensions (mm) vs. Tangential Loads (N) for KM32TS Depth of Cut (mm) and Feed Rate (mm/rev) vs. Tangential Forces (N) for KM32TS feed rate (mm/rev) M40 n, KENNAMETAL