1427 Каталог KENNAMETAL 2013 Инструментальная оснастка для металлорежущих станков Стр.M27

Каталог KENNAMETAL 2013 Инструментальная оснастка Стр. M27 1427 Lab2u

Kennametal Technical Information KM Manual Clamping System KM Manual Clamping Unit Disassembly Procedures (continued) 6. Clean locking balls, torque screw, lockrod, and bump-off pin of all grease and inspect for wear, burrs, or obvious damage. If rebuilding the unit with a repair parts package, we recommend using all new components contained in the kit. If you are not using the repair package, but are retiming or adjusting the unit, inspect the external threads on the torque screw and lockrod, the locking ball contact surfaces on the lockrod, and the mating surfaces between the lockrod and bump-off pin. Discard any components of questionable condition and replace with new ones. Note the condition of the raised taper key on the lockrod as you will need this later. 7. Inspect inside the KM taper for damage and/or contamination. Clean the taper and canister with solvent. Allow the unit to dry before reassembling. Inspect the torque screw threads in the body for damage. 8. If the unit is equipped for through-coolant capability, you may want to verify that the coolant passages are clear. Clean if required. KM size torque screw hex size KM32 5mm KM40 6mm KM50 10mm KM63 12mm KM80 14mm Kennametal M27 Technical Information