633 Каталог GEDORE 2014 Профессиональный слесарный инструмент и оборудование Стр.631

Каталог GEDORE 2014 Слесарный инструмент Стр. 631 0633 ENG Lab2u

Screwdrivers Choose the screwdriver which is suitable for the respective bolt head profile. Place the workpiece on a ledge or clamp it. This helps to avoid injuries incurred by sliding blades. Avoid cuts by directing the requisite pressure for releasing or tightening the bolt head away from your body. Wear protective gloves when working with screwdrivers. If the screwdriver is too long do not under any circumstances shorten the blade or handle. Choose a shorter screwdriver. Do not use the screwdriver as a caulking or crushing tool. Light hammer impact may only be applied for loosening screws using suitable screwdrivers with striking cap or continuous blade. If the bolt fails to loosen use the GEDORE impact driver set no. K 1900-013 to release the bolt without destroying it. Insulated and tested screwdrivers must be used when working on electrical systems. VDE tools Work on electrically live equipment may only be carried out by trained electricians. Only tools and safety equipment marked with the double triangle or bell 1000 V symbol (refer to BGV A3) may be used. Before commencing any work check the insulation for damage. Damaged tools must not be used. The regulations of the employers' liability insurance associations and power supply companies must be complied with. GEDORE VDE tools are approved for work on live circuits at voltages up to 1000 V AC and 1500 V DC. Tools must not be combined unless they are designed to be securely joined together. Pullers Read the operating instructions Use only original spare parts and accessories for your GEDORE puller. Never use worn modified or defective spare parts or accessories. Wear goggles and protective clothing when working. For added safety use the GEDORE safety cover 5.10 Before pulling ensure that the legs are in contact with the part to be pulled and are firmly tightened so that the spindle operates centrally along the axis of the puller. Attention When using a puller forces of up to several tons are generated Take care to ensure that the puller is correctly positioned and is vertical to the component being pulled. Do not use electric or pneumatic power or percussion drivers. Ratchets tools and sockets Ratchets are suitable for swift releasing and tightening. Avoid jerky movements with the ratchet e.g. caused by hammer impact. The square drive and the tool and socket square drive must be of the same size. Select the drive size in accordance with the screwed connection. This particularly applies to screwed connections with high torques. Ensure that the ball engages properly in the ball catch. Always pull the tool towards you. Never push the tool away from you. If for design reasons you can only press the tool away from you use your open hand to prevent injuring your knuckles. Only use suitable sockets and connections for the impact driver. Use a safety pin and ring to secure the connection between the socket extension and machine. When using reducers the smaller drive's torque always applies. Do not use ratchets as levers or as striking tools. 3 mm min. ts y -4 A 631 T