Сверла Митсубиси по металлу Японский осевой режущий инструмент для сверления отверстий DRILLING

Сверла Митсубиси по металлу Японский осевой режущий инструмент для сверления отверстий DRILLING

Сверла Митсубиси по металлу Японский осевой режущий инструмент для сверления отверстий DRILLING _ 1 STAW NOTES ON USE INSERT INSTALLATION 1. Before inserting the insert into the holder, ensure that there are no foreign objects or dirt in the holder slot or slit. If there are any foreign objects or dirt, use compressed air to remove them. 2. Use the provided wrench to loosen the inner screw to open the tip of the holder, then put the insert into the holder slot as shown in figure 1. 'Ensure that the wrench is firmly in contact with the base of the inner screw head when tightening. 3. After the insert has been set in the holder slot, tighten the inner screw while holding the insert lightly as shown in figure 2 to securely clamp and locate the insert. 'Ensure that the wrench is firmly in contact with the base of the inner screw head when tightening. Tighten the clamp screw according to the torque below. Drill Diameter (mm) Clamp Torque N m 10 -12.9 1 13 -15.4 2 15.5-18.4 2.5 Internal screw - Stopper Holder slot 4. Check there is no gap between the bottom of the insert and holder slot. Alignment mark niiynmcTir OK J (Note) Poor or incorrect clamping of inserts can cause poor drilling performance and/or drill breakage. Therefore ensure that the alignment marks on both the body and insert are aligned when setting. When machining, use safety guards and goggles. 1888 Mitsubishi Materials