Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS

Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS

Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS _ TAPER RADIUS BALL SQUARE carbide Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS _ VCZMS Рекомендуемые режимы резания при обработке на станке RECOMMENDED CUTTING CONDITIONS Work material Carbon steel, Cast iron, Alloy steel, Pre-hardened steel AIS11050, AISI No 35 B, AISI P20, AISI P21 Hardened steel (45 55HRC) AISI H13 Oil DC mm Feed nte (mmlmin) Deptiifcut i mn Revdition nir') Feed nte (mmlnin) Dqirfcil i(nn) 0.3 0.5 1.5 2.5 10 12 16 20 40000 40000 40000 40000 30000 24000 20000 15000 12000 10000 8000 6400 5400 2400 1900 200 950 2000 3000 3000 2600 2300 2000 1600 1400 1000 900 820 380 320 0.005 0.015 0.06 0.12 0.18 0.25 0.30 0.40 0.50 0.60 0.80 1.00 1.00 3.00 4.00 40000 40000 32000 32000 24000 19000 16000 12000 9000 7000 5600 4500 3800 1200 1000 200 950 1600 1900 1900 1600 1400 1200 900 700 550 500 450 100 80 0.005 0.015 0.06 0.08 0.10 0.13 0.15 0.20 0.25 0.30 0.40 0.50 0.50 0.80 1.00 If the depth of cut is shallow, the revolution and feed rate can be increased. In case of slotting with over 3 mm endmill, please reduce revolution to 50 70% of above value, and reduce feed rate to 40 60% of above value. When drilling, please set the feed rate at 1/3 or below of the values above. If the rigidity of the machine or the work materials installation is very low, or chattering and noise are generated, reduce the revolution and feed rate proportionately. 732 Mitsubishi Materials