Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS

Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS

Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS _ TAPER RADIUS BALL SQUARE Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS _ VA4MC Рекомендуемые режимы резания при обработке на станке RECOMMENDED CUTTING CONDITIONS Side milling Work material Structural steel, Cast iron, Carbon steel AIS11045, AISI No 35 B, AIS11050 Carbon steel, Alloy steel (20 30HRC) AIS11055, AISI P20 Alloy steel, Tool steel, Prehardened steel (30 35HRC) AISI H13, AISI D2 Austenitic stainless steel, Alloy steel, Tool steel (35 40HRC) AISI 304, AISI 316 Oil. DCjmm Mutton (miir1) Fnd nte (mm/min) Mutton jmin-1) FhiI nte tnmlmin) Mutton (miir1) FHd nte (mmMiin) Mutiin (miir1) Feed nte miMi) 3 5400 270 4000 200 2700 140 2200 100 4 4300 320 3200 240 2100 160 1800 120 5 3600 340 2700 250 1800 170 1500 130 6 3200 350 2400 260 1600 180 1300 140 8 2400 380 1800 290 1200 190 1000 145 10 1900 420 1400 300 950 210 800 160 12 1600 380 1200 290 800 190 660 145 16 1200 340 900 260 600 170 500 130 20 950 290 720 220 480 140 400 110 25 760 240 570 180 380 120 320 100 30 640 210 480 160 320 100 270 80 <1.5DC If the rigidity of the machine or the work materials installation is very low, or chattering and noise are generated, reduce the revolution and feed rate proportionately. 1170 Mitsubishi Materials