Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS

Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS

Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS _ VCHFRB The cutting conditions above are a guide only to machining with cutting edges with a corner radius. This table shows the cutting conditions with less than 5DC overhang length. In the case of longer overtiangs, the revolution and the feed rate should be reduced proportionately. If the depth of cut is shallow, the revolution and feed rate can be increased. Air blow or oil mist is recommended for good chip evacuation. For profile machining such as moulds, machining conditions may differ considerably depending on the workpiece geometry, machining methods and depth of cut. Reduce the feed rate especially when machining the corner sections of a workpiece. When machining inclinations in the Z direction, set the inclination angle at 2° and reduce the feed rate by 50%. If the rigidity of the machine or the work materials installation is very low, or chattering and noise are generated, reduce the revolution and feed rate proportionately. Mitsubishi Materials 1059 Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS _ TAPER RADIUS BALL SQUARE carbide