Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS

Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS

Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS _ VC4JRB Рекомендуемые режимы резания при обработке на станке RECOMMENDED CUTTING CONDITIONS When cutting austenitic stainless steel, the use of water-soluble cutting fluid is effective. If the depth of cut is shallow, the revolution and feed rate can be increased. The above table shows cutting conditions for standard side milling. For slotting, please reduce the feed rate only to 50% of the table figure. Please set the revolution rate at 60% and the feed rate at 40% when slotting austenitic stainless steels. When drilling, please set the feed rate at 1/3 or below of the values above. If the rigidity of the machine or the work materials installation is very low, or chattering and noise are generated, reduce the revolution and feed rate proportionately. Mitsubishi Materials 1055 Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS _ TAPER RADIUS BALL SQUARE carbide