Токарные пластины Mitsubishi TURNING INSERT

Токарные пластины Mitsubishi TURNING INSERT

Токарные пластины Mitsubishi TURNING INSERT _ CLASSIFICATION 5° POSITIVE INSERTS WITH HOLE CL CL < Breaker Name and Picture Features Cross Section Geometry First recommendation for finishing carbon steel and alloy steel Breaker protrusion at the corner tip controls chips even at small depth of cut. Maintains the edge strength at the comer and prevents sudden fractures. Carbon Steel Alloy Steel 3T 2 Nose 0 0.1 0.2 0.3 0.4 f (mm/rev) M O) c s 3 u £ .2 "E First recommendation for finishing stainless steel Breaker protrusion at the corner tip controls chips even at small depth of cut. Maintains the edge strength at the comer and prevents sudden fractures. Stainless Steel 3 I2 ft 0 Nose 0.1 0.2 0.3 0.4 f (mm/rev) First recommendation for finishing carbon steel, alloy steel, mild steel and stainless steel Suitable for low depths of cut and low feed rates. Sharp cutting edge and low resistance design achieves excellent cutting performance. Carbon Steel Alloy Steel Nose 3 h ro 1 0 Flank 0.1 0.2 0.3 0.4 f (mm/rev) Finishing Lead chipbreaker controls chip flow. Sharp cutting edge gives a good surface finish. Carbon Steel Alloy Steel 3 I2 (0 1 0 Flank 0.1 0.2 0.3 0.4 f (mm/rev) First recommendation for light cutting of carbon steel and alloy steel Sharp cutting edge due to a large rake angle. Prevents welding of the insert and controls white turbidity of the surface finish. Breaker protrusion suitable for depth of cut area achieves a wide range of chip control. Carbon Steel Alloy Steel 3 I2 Nose Q. -CD 1 0 I 'l 18° U. I u.z. u.o f (mm/rev) Flank 8°f r /" Ui c s 3 o M First recommendation for light cutting of stainless steel Sharp cutting edge due to a large rake angle. Prevents welding of the insert and controls white turbidity of the surface finish. Breaker protrusion suitable for depth of cut area achieves a wide range of chip control. Stainless Steel 3 I2 Nose 0 0.10.2 0.3 0.4 f (mm/rev) sv Light cutting of carbon steel, alloy steel, mild steel and stainless steel Large rake angle provides sharp cutting action. A peninsular dot ensures chip control at depths of cut under 1 mm. Carbon Steel Alloy Steel 3 I So 1 Nose I "I Flank 0 0.1 0.2 0.3 0.4 f (mm/rev) s =- V'"- Ol c 5 3 o E First recommendation for medium cutting of cast iron Optimum balance between sharpness and high edge strength for general use. Cast Iron 3T 2 Flank M 0 0.1 0.2 0.3 0.4 f (mm/rev) 0.1 First recommendation for medium cutting of carbon steel and alloy steel Good balance of wear resistance and fracture resistance because of the flat land cutting edge. A wide chip pocket controls increasing of the cutting resistance and reduces vibration and chip jamming even at large depth of cut. Carbon Steel Alloy Steel 3 2 ro 1 ° 0.10.2 0.3 0.4 f (mm/rev) 18' 18' Nose 0.1 Flank 82 Mitsubishi Materials