Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS

Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS

Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS _ TAPER RADIUS BALL SQUARE carbide Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS _ VFBWB Рекомендуемые режимы резания при обработке на станке RECOMMENDED CUTTING CONDITIONS Work material Carbon steel, Cast iron, Alloy steel ( 30HRC) AIS11050, AISI No 35 B, AISI P20 Alloy steel, Tool steel, Pre-hardened steel AISI H13, AISI W1-10, AISI P21 Austenitic stainless steel. Titanium alloy AISI 304, AISI 306, Ti-6AI-4V Hardened steel (45 55HRC) AISI H13 R REM Revolution (mir1) Feed iite (mmlmin Dqiofcut ip M Revolution (mir1) Feed rate (mmMi n Dqoth of cut ip M Revdution (miir1 Feed nte (mmimin Depth dot ip (mm Revdution (niir1 Feed nte (mmlmh Dejitti of cut )P (mm) R1 40000 5000 0.07 40000 5000 0.06 32000 2500 0.05 32000 3000 0.03 R1.5 32000 5000 0.12 32000 5000 0.11 26000 2500 0.10 26000 3000 0.07 R2 24000 3800 0.15 24000 3800 0.13 20000 2000 0.12 20000 2800 0.10 R3 16000 2800 0.20 16000 2800 0.18 13000 1500 0.15 13000 2100 0.12 £0.05RE(RE = 1) <0.1RE(RE>1) When cutting austenitic stainless steel, the use of water-soluble cutting fluid is effective. If the depth of cut is shallow, the revolution and feed rate can be increased. 930 Mitsubishi Materials