Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS

Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS

Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS _ VCMH Рекомендуемые режимы резания при обработке на станке RECOMMENDED CUTTING CONDITIONS Work material Carbon steel. Cast iron, Alloy steel, Pre-hardened steel AIS11050, AISI No 35 B, AISI P20, AISI P21 Austenitic stainless steel. Titanium alloy AISI 304, AISI 306, Ti-6AI-4V Hardened steel (45 55HRC) AISI H13 Heat resistant alloys lncone 718 Dia. Revolution Feed rate RevoMon Feed nte Rewlutiei Feed nte RevMon Feed rale DC(mm (mir'l (mm/min miit4 (mmlmil) (miir1) (inmMn) (mir') m/min) 3 5300 130 4400 100 2400 50 1500 25 4 4400 220 3700 160 2000 80 1300 40 5 3600 260 3000 190 1700 100 1100 50 6 3200 280 2700 200 1500 100 1000 50 8 2400 300 2000 210 1200 110 800 45 10 1900 290 1600 210 960 115 640 45 12 1600 250 1300 170 800 95 530 40 16 1200 180 1000 130 600 70 400 30 18 1100 170 900 120 530 65 350 25 20 960 190 800 140 480 75 320 25 25 760 150 640 110 380 60 260 20 <0.05DC If the depth of cut is shallow, the revolution and feed rate can be increased. The above table shows cutting conditions for standard side milling. For slotting, please set the revolution at 80 100% and the feed rate at 60 80% of the table figure. Please set the revolution rate at 60% and the feed rate at 40% when slotting austenitic stainless steels. If the rigidity of the machine or the work materials installation is very low, or chattering and noise are generated, reduce the revolution and feed rate proportionately. Mitsubishi Materials 787 Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS _ TAPER RADIUS BALL SQUARE carbide