Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS

Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS

Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS _ MS4LTB Рекомендуемые режимы резания при обработке на станке RECOMMENDED CUTTING CONDITIONS Work material Carbon steel, Cast iron, Alloy steel, Pre-hardened steel AIS11050, AISI No 35 B, AISI P20, AISI P21 Hardened steel (45 55HRC) AISI H13 R RE (mr Length of Cut APIUqmm Revolution Feed rate (mmlmin) Depth of cut ip(mm) Revolution (min4 Feed nte ImmMn) Depth of cut m) R0.3 4 18000 32000 250 600 0.01 13000 24000 200 400 0.005 6 0.007 0.004 R0.4 6 14000 24000 250 600 0.025 10000 18000 200 400 0.013 8 0.02 0.01 10 0.015 0.008 R0.5 8 11000 19000 300 800 0.025 8000 14000 200 500 0.013 10 0.02 0.01 12 0.018 0.009 16 0.015 0.008 R0.6 8 9200 16000 300 800 0.035 6600 12000 200 500 0.018 10 0.03 0.015 12 0.027 0.013 16 0.02 0.01 R0.75 8 7500 13000 300 800 0.05 5300 9500 200 500 0.025 10 0.04 0.02 12 0.035 0.018 16 0.03 0.015 20 0.02 0.01 R0.9 8 6200 11000 300 800 0.08 4400 8000 200 500 0.04 10 0.07 0.035 12 0.06 0.035 16 0.05 0.03 20 0.04 0.02 R1 10 5500 9500 300 800 0.08 4000 7200 200 500 0.045 12 0.07 0.04 16 0.05 0.03 20 0.04 0.02 25 0.03 0.015 30 0.02 0.01 If the depth of cut is shallow, the revolution and feed rate can be increased. Cutting condition may be considerably different due to the overhang (milling depth), depth of cut, and machine tools. Please see the above table as a standard. Mitsubishi Materials 1103 Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS _ TAPER RADIUS BALL SQUARE carbide