668 Каталог HOFFMANN GROUP 2016 Станочный режущий и вспомогательный инструмент Вер. 47 Стр.668

Каталог HOFFMANN GROUP 2016 Режущий инструмент и оснастка Стр. 668 0668 ENG Lab2u

Hoffmann Group 47 Pictograms Standard DIN 69871 ISO 7388-1 DIN 2080 DIN 6358 DIN 69882-2 ISO 26623-1 DIN 69872 ISO 7388 MAS 403 DIN 6499 A DIN 6499 B ISO 15488-A JIS ISO DIN ISO DIN B6339 7388-2 69893 12164-1 6359 Arbor shank type. gripper groove and interface correspond ISO ISO to this DIN. 26622-1 12164-3 Pull studs correspond to this DIN. ISO 15488-B DIN 2084 ER / OZ collets / damping nuts, and accessories correspond to this DIN. r'W'JI Standard Manufacturer's standard Coolant supply Note; CS = Coolant supply / ICS = Internal coolant supply / CCB = Cooling channel bores. Form A Form E Form F For ISO tapers; no central coolant supply available (the arbor is not bored through . For hollow shank taper: central axial coolant supply available via a coolant pipe. Form F: no central coolant supply available, only through bored. Form AD For ISO taper arbors; Coolant supply only centrally through the arbor arbor through bored). Form ADB For ISO taper arbors: Coolant supply centrally = form AD) or laterally via the collar (=form B). 50 bar Internal coolant supply limited to maximum 50 bar, or suitable for internal coolant supply. Arbors with cooling channel bores and plugging threads. 1 Arbors with cooling channel bores cannot be plugged. Radial run-out 6nmJ (ilOum '<30nmj (£50tim Radial run-out of various arbors and short drill chucks. Run-out of ER collets: HP = High precision ER collet (2 im) FAHRION ER standard collet (5 pm) FAHRION ER standard collet 10 pm) HOLEX / s3nm / £6 im / j10jjm System run-out ER precision collet chuck FAHRION Centro P (CP) HP+CP ER+CP OZ+CP in conjunction with FAHRION ER collets (HP or standard) or OZ collets type 444E). Balancing quality G6.3 8000 min'1 G6.3 G6.3 G 6.3 G2,5 12000 15000 20000 18000 min'1 min'1 min'1 min'1 G2.5 25000 min'1 G 2.5 G 2.5 30000 40000 min'1 min'1 Balancing quality of various arbors: e.g. precision balanced to G2.5 at 25000 rpm. Application HSC <57 67 Arbor suitable for Highspeed Cutting Tool dust-tight and watertight HPC O 14Nm Arbor suitable for High Performance Cutting. Maximum tightening torque (MDniJ. For HSK arbors: Form -Application in machining centres Form A -Torque transmission by E 2 drive slots at the end of the taper For HSK arbors: - Used for high frequency spindles e.g. woodworking madiines) - Rotationally symmetrical, without drive slots. - Torque transmission by friction. Vibration damping 668