109 Каталог DEREK 2017 Режущий инструмент и оснастка инструментальная для станков Стр.A77

Каталог DEREK 2017 Инструмент и оснастка для станков Стр. A77 0109 Lab2u

DBJ10/12/16 DBJ 10/12/16 Micro-Boring Head Manuals Operating Instructions &m . iitsiniiEBrtJiff, irt, i°io wmjinmmmm (u) &m : mfflwtmmmm (u) =: ins in ia ( b ) &.2.&/K umffiflsia fio fi i / \/f 0.01mm Step 1: Hold right boring bar in right hole. Make sure weldon part of boring bar is to the position of lock screw and cutting edge of boring bar is to the the position of adjusting panel. Fasten the locking screw properly. Step 2: Loosen adjusting screw (see figure 4) anti-clockwise. Step 3: Enlarge the boring diameter by adjusting on the adjusting panel (see figure 2) anti-clockwise, while adjusting clockwise is to reduce the boring range. Step 4: Adjust till the boring diameter required and lock the adjusting screw properly. slippfta Manuals litsfffi Connection part 2 tsl fS Tool body Adjusting knob Locking screw mTinmmm Mounting screw 6 Jiff Boring bar Notices Of The User 4. ipnp 1.Please use this tool within work range. 2.Please loosen the adjusting screw before adjusting. 3.Please fasten the adjusting knob by means of special wrench properly. 4.Please stop the adjustment when it is faced with a strong resistance, or it is not able to go on. And make sure: A. If the locking screws is unlocked; B. If the adjustment is within the suggested work range; C.Over adjustment will bring damage to the tool irreversibly. III Instruction DEREK