Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS

Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS

Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS _ VF2MD Рекомендуемые режимы резания при обработке на станке RECOMMENDED CUTTING CONDITIONS Work material Alloy steel, Tool steel, Pre-hardened steel AISI H13, AISI W1-10, AISI P21 Hardened steel (45 55HRC) AISI H13 Hardened steel (55 62HRC) AISID2 Oil DCfynm) (miir'l Feedale mMn Depth of cut i mm) Revolution (mill4 Depth of out ajrnm) Revolution (miir' Feed rate (mmlmin) Depth of cut i(m 0.5 1.5 2.5 40000 40000 40000 30000 24000 20000 15000 12000 10000 1000 2000 3000 3000 2600 2300 2000 1600 1400 0.015 0.06 0.12 0.18 0.25 0.30 0.40 0.50 0.60 40000 32000 32000 24000 19000 16000 12000 9000 7000 960 1600 1900 1900 1600 1400 1200 900 700 0.015 0.06 0.08 0.10 0.13 0.15 0.20 0.25 0.30 30000 16000 10600 8100 6400 5400 4000 3200 2700 600 550 500 400 350 300 240 190 160 0.01 0.05 0.08 0.1 0.13 0.15 0.2 0.2 0.2 1DC If the depth of cut Is shallow, the revolution and feed rate can be Increased. When drilling, please set the feed rate at 1/3 or below of the values above. If the rigidity of the machine or the work materials installation is very low, or chattering and noise are generated, reduce the revolution and feed rate proportionately. Mitsubishi Materials 721 Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS _ TAPER RADIUS BALL SQUARE carbide