Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS

Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS

Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS _ MSZMRB Рекомендуемые режимы резания при обработке на станке RECOMMENDED CUTTING CONDITIONS Work material Carbon steel, Cast iron, Alloy steel, Pre-hardened steel AIS11050, AISI No 35 B, AISI P20, AISI P21 Hardened steel (45 55HRC) AISI H13 Dii Rivdufitn Fnd rati Di iofail RivoMon Fnd rati Dqiofcil DCH (mir1 (mmMiinl itnm) (mir1 (mmhnn iH 0.1 40000 40 0.001 40000 40 0.001 0.2 40000 100 0.002 40000 100 0.002 0.3 40000 200 0.005 40000 200 0.005 0.4 40000 600 0.01 40000 600 0.01 0.5 40000 1000 0.015 40000 960 0.015 0.6 40000 1200 0.02 40000 1200 0.02 0.7 40000 1400 0.02 40000 1400 0.02 0.8 40000 1600 0.03 40000 1600 0.03 0.9 40000 1800 0.04 40000 1600 0.04 1 40000 2000 0.06 32000 1600 0.06 1.5 40000 3000 0.12 32000 1900 0.08 2 30000 3000 0.18 24000 1900 0.10 2.5 24000 2600 0.25 19000 1600 0.13 3 20000 2300 0.30 16000 1400 0.15 4 15000 2000 0.40 12000 1200 0.20 5 12000 1600 0.50 9000 900 0.25 6 10000 1400 0.60 7000 700 0.30 8 8000 1000 0.80 5600 550 0.40 10 6400 900 1.00 4500 500 0.50 12 5400 820 1.00 3800 450 0.50 16 2400 380 3.00 1200 100 0.80 20 1900 320 4.00 1000 80 1.00 JJp -1DC If the depth of cut is shallow, the revolution and feed rate can be increased. In case of slotting with over 3 mm endmill, please reduce revolution to 50 70% of above value, and reduce feed rate to 40 60% of above value. When drilling, please set the feed rate at 1/3 or below of the values above. If the rigidity of the machine or the work materials installation is very low, or chattering and noise are generated, reduce the revolution and feed rate proportionately. Mitsubishi Materials 987 Концевые фрезы Mitsubishi Materials по металлу SOLID END MILLS _ TAPER RADIUS BALL SQUARE carbide