Фрезы Mitsubishi со сменными режущими пластинами INDEXABLE MILLING

Фрезы Mitsubishi со сменными режущими пластинами INDEXABLE MILLING

Фрезы Mitsubishi со сменными режущими пластинами INDEXABLE MILLING _ vwaaa INSERTS Обозначение Order Number Class PCD MD220 Geometry N P-G DCW1240PDFR2 C CN 9.5 4 N 2 -CM 15 18’ Inventory maintained in Japan. (1 insert in one case) Рекомендуемые режимы резания при обработке на станке RECOMMENDED CUTTING CONDITIONS Обрабатываемые материалы Work Material Silicon (%) Скорость резания (м/мин) Cutting Speed (m/min) Подача на зуб Feed per Tooth (mm/t.) Глубина резания (мм) Depth of Cut (mm) <16 -6500 Aluminium -0.2 -0.5 Alloy >16 -1000 NOTE ON ROTATIONAL BALANCE At the time of shipping, the cutter body is balanced by using a special high accuracy master insert in order that it will conform to balance quality G6.3 based on ISO 1940/1 (approximate value at the maximum revolution for each cutter diameter). In order to keep good rotational balance, do not adjust the balance screw (HSS05005) located on the outer surface of the body. 9 Rotational balance will change after exchanging cartridges. If you use the cutter at the same revolution as that of the following table or higher, re-balancing is necessary after exchanging cartridges. Please contact Mitsubishi Materials to re-balance the cutter. (Note 1) If the revolution is the same as or lower than the value indicated above, the cutter can be used with a standard arbor. (Do not use long shank type arbors or special arbors, as the overtiang could make it dangerous to use.) (Note 2) If the revolution is higher than the value indicated above, please set the balance as follows (Arbor + cutter)