1275 Каталог MITSUBISHI 2015 Токарный и вращающийся инструмент Инструментальные решения Стр.L147

Каталог MITSUBISHI 2015 Металлорежущий инструмент Стр. L147 1275 ENG Lab2u

FACE MILLING HIGH SPEED FINISHING ALUMINIUM ALLOY viaaaa Finishing M i n Non-ferrous Metal Mm KAPR :0 GAMP:+8 GAMF :+8 Insert with PCD. Light weight strong aluminium alloy cutter body. Anti-Fly insert mechanism enables high speed milling. Adjustable cutting edge run-out function. Right hand tool holder only. Order Number Stock Number 1 of Teeth Dimensions (mm) WT (kg) APMX (mm) Max. Allowable Revolution (min-1) Type (Fig.) R DC LF DCON CBDP DAH DCCB KWW L8 V10000-063A04R 4 63 50 22 20 11 - 10.4 6.3 0.5 1.5 25000 1 01 R0305C 5 80 50 25.4 26 - 38 9.5 6 0.6 1.5 22300 2 R0406D 6 100 50 31.75 32 - 45 12.7 8 0.9 1.5 20000 2 R0508E 8 125 63 38.1 35 - 60 15.9 10 1.8 1.5 17800 2 WT Tool Weight SPARE PARTS Tool Holder Number r t Cartridge Cartridge Clamp Screw-A Cartridge Clamp Screw-B Insert ClamD Screw Run-out Adjust Screw Balance Adjust Screw Wrench Wrench V10000-063A04R i V10000R0508E VCT13R HBH06016 HBH04008 CS350790T KS1 HSS05005 HKY25R HKY40R TKY10R Clamp Torque (N m) CS350790T3.5 HBH060168.0 HBH040084.0 INSERTS RECOMMENDED CUTTING CONDITIONS Work Material Silicon (%) Cutting Speed (m/min) Feed perTooth (mmAooth) Depth of Cut (mm) N 16 -6500 Aluminium -0.2 -0.5 j Alloy 16 -1000 NOTE ON ROTATIONAL BALANCE At the time of shipping the cutter body Is balanced by using a special high accuracy master insert in order that it will conform to balance quality G6.3 based on ISO 1940 1 (approximate value at the maximum revolution for each cutter diameter). In order to keep good rotational balance do not adjust the balance screw (HSS05005) located on the outer surface of the body. Rotational balance will change after exchanging cartridges. If you use the cutter at the same revolution as that of the following table or higher re-balancing is necessary after exchanging cartridges. Please contact Mitsubishi Materials to re-balance the cutter. (Note 1) If the revolution is the same as or lower than the value indicated above the cutter can be used with a standard arbor. (Do not use long shank type arbors or special arbors as the overhang could make it dangerous to use.) (Note 2) If the revolution is higher than the value indicated above please set the balance as follows (Arbor + cutter)G6.3 Inventory maintained in Japan. (1 insert in one case) Balance adjust screw Run-out adjust Screw Cartridge set screwA Cartridge Insert Diameter of cutter (mm) Revolution requiring re-balancing (min-1) 63 17000 80 14500 100 14000 125 Re-balancing not necessary up to the max. revolution SPARE PARTS -P001 TECHNICAL DATA -Q001 L147 MILLING