System overview of Walter Turn / Walter Capto External machining External toolholder for indexable inserts with a negative basic shape Walter Tur

System overview of Walter Turn / Walter Capto External machining External toolholder for indexable inserts with a negative basic shape Walter Tur

System overview of Walter Turn / Walter Capto External machining External toolholder for indexable inserts with a negative basic shape Walter Turn rigid clamping system (D) The number one choice for machining short-chipping material such as cast iron Functionality is also maintained in “dirty environments , e.g. chilled cast iron machining The number one choice with interrupted cuts thanks to extremely stable insert clamping Indexable insert and shim replaced using the same wrench Reinforced top clamp with carbide shoe for longer top clamp service life Walter Turn lever-type clamping (P) Universal system with easy indexable insert replacement The number one choice for single-sided negative inserts, e.g. SNMM for heavy roughing Unobstructed chip evacuation and usable as an alternative to the rigid clamping system Walter Turn wedge-type clamping system (M) For indexable inserts with a negative T basic shape Profiling is possible up to an angle of 22° with TNMG indexable inserts Insert that is frequently used when shaft machining with undercuts Walter Valenite Common Hardware top clamp system Top clamp lock pin system for all negative style inserts Good for all types of applications including heavy roughing External toolholder for indexable inserts with a positive basic shape Walter Turn screw clamping (S) For indexable inserts with positive basic shape with clearance angle of 5° and 7° The number one choice for use with low cutting pressures / small diameter shafts Fewer assembly parts are needed Torx Plus screw clamping for transmitting higher tightening torques Indexable insert and shim replaced using the same wrench Walter Turn positive lever type clamping (P) For indexable inserts with positive V/R basic shape with clearance angle of 5° and 7° A high degree of shape accuracy is achieved on the component because of the large amount of pre-tension via the knee lever with V inserts No danger of the clamping screw slackening during machining because of round insert distortion A 134 WALTER Valenite Turning