398 Каталог SUMITOMO 2015 Режущий инструмент и инструментальная оснастка Стр.394

Каталог SUMITOMO 2015 Инструмент и оснастка Стр. 394 0398 ENG Lab2u

PCBN & PCD Milling SUMIDIA MILLS SRF Type suMIDIA Cutter for High speed Finishing of Non-ferrous Metal Fig 1 Fig 2 Fig 3 Fig 4 SRF Endmill Availability - METRIC Sumitomo Catalog No. Stock 0D (mm) of Teeth Fig. SRF30R-ST 30.0 3 1 SRF40R-ST 40.0 4 1 SRF30R-BT30 30.0 3 2 SRF40R-BT30 40.0 4 2 SRF30R 30.0 3 3 SRF40R 40.0 4 3 SRF50R 50.0 5 4 SRF63R 63 .0 6 4 Parts t R0.5mm Maximum D.O.C. Guide (SRF50R, 5 teeth) Below are guidelines for maximum D.O.C based on internal test results .' indicates possible application range. Actual cutting condtions should be set based on actual machine and work piece characteristics Inserts Sumitomo Catalog No. Cutting Edge SUMIDIA DA1000 Fig. NF-SNEW09T3ADTR Standard 1 NF-SNEW09T3ADTR-U Wiper 2 NF-SNEW09T3ADTR-R Nose Radius 3 Standard inserts and wiper inserts can be used on the same cutter body. Standard inserts with nose radius should be used where vibration is present. Wiper inserts are not recommended Inserts can be reground 3 times (up to I.C. diameter of 9.225 mm/0.3632 in.) When using reground inserts, it is recommended to reconfirm insert height and cutting diameter with a tool pre-setter. Do not mix new and reground inserts OR inserts with different regrind measurements on the same cutter Standard inserts and wiper inserts can be used on the same cutter body. arbor for SRF30R & SRF40R (22mm When using the SRF30R or SRF40R cutters, modification to the arbor is required, as shown above. 1) Reduce part of the arbor's adaptor shaft from 025.4mm to 015mm 2) Add four tap holes for M5 cap screws. Feedrate, F ipm (mm/min) D.O.C. 100 (2500) 160 (4000) 200 (5000) in (mm) Feed per tooth, f ipt (mm/tooth) 0.002 (0.05) 0.003 (0.08) 0.004 (0.10) 0.20 (0.5) 0 .40 (1.0) 0 .60 (1.5) 0 .80 (2.0) 0 .10 (2.5) 0 .12 (3.0) 0 .14 (3.5) - 0 .16 (4.0) 0 .18 (4.5) 0.20 (5 .0) Cutting Conditions Cutter SRF50R Insert NF-SNEW09T3ADTR (DA2200) Arbor BT30 FMA25 4-45 Work A-5052 Width 35mm (1.40 in.) at D.O.C indicated above 394