784 Каталог MITSUBISHI 2020 Режущий инструмент Фрезы Резцы Сверла Пластины Стр.J162

Каталог MITSUBISHI 2020 Режущий инструмент для станков Стр. J162 0784 Lab2u

SOLID END MILLS VQXL End mill, Short cut length, 4 flute, Long neck RECOMMENDED CUTTING CONDITIONS Bottom face milling Work Material Carbon steel, Alloy steel, Austenitic stainless steels, Titanium alloys Cobaly chromium alloy, Copper, Copper alloy Heat resistant alloys, Pre-hardened steel, Hardened steel AISI 1045, AISI 4140, AISI 4340, AISI 304, AISI 316, AISI 304LN, AISI 316LN, Ti-6AI-4V lnconel718, AISI P21, AISI P20, AISI H13, AISI L6, AISI 431, AISI 420 Dia. DC (mm) Neck Length LU (mm) Cutting speed (m/min) Revolution (min-1) Feed rate (mm/min) Depth of cut ap (mm) Depth of cut ae (mm) Cutting speed (m/min) Revolution (min-1) Feed rate (mm/min) Depth of cut ap (mm) Depth of cut ae (mm) 0.2 0.6 25 40000 360 0.015 0.2 20 32000 290 0.015 0.1 0.3 0.9 40 40000 480 0.025 0.3 20 21000 250 0.025 0.15 0.3 1.5 40 40000 360 0.02 0.3 20 21000 190 0.02 0.15 0.4 1 50 40000 800 0.03 0.4 20 16000 320 0.03 0.2 0.4 1.8 50 40000 560 0.02 0.4 20 16000 220 0.02 ,0.2 0.5 1.5 60 38000 910 0.04 0.5 20 13000 310 0.04 0.25 0.5 2.5 60 38000 610 0.03 0.5 20 13000 210 0.03 0.25 0.5 3 60 38000 550 0.03 0.5 20 13000 180 0.03 0.25 0.6 3 60 32000 640 0.035 0.6 20 10500 210 0.035 0.3 0.7 3.5 60 27000 640 0.035 0.7 20 9100 190 0.035 0.35 0.8 2.4 60 24000 960 0.06 0.8 20 8000 260 0.06 0.4 0.8 3 60 24000 840 0.05 0.8 20 8000 230 0.05 0.4 0.8 4 60 24000 670 0.04 0.8 20 8000 190 0.04 0.4 1 5 60 20000 800 0.05 1 20 6500 210 0.05 0.5 ae Note 1) SMART MIRACLE Coating is not energized because of its nature. Therefore, an external contact (voltaic type) tool setter cannot be used. An internal contact (non-voltaic) type or laser type tool setter is recommended to measure the length of the tool. Note 2) Effective cutting of stainless steel, titanium alloys and heat-resistant alloys etc. can be achieved with the use of emulsion. Note 3) When the depth of cut is smaller than shown the revolution and feed rate can be increased.