390 Каталог KYOCERA 2017 Инструмент сборный и монолитный для станков Стр.G29

Каталог KYOCERA 2017 Инструмент режущий Стр. G29 0390 Lab2u

Recommended Cutting Conditions Рекомендованные режимы резания на станках Recommended Cutting Conditions Рекомендованные режимы резания на станках (Vc) Workpiece Material Обрабатываемый материал Chipbreaker Стружколом сменной пластины Recommended Insert Grades Cutting Speed Vc (m/min) Скорость резания (м/мин) Remarks Примечания Cermet MEGACOAT NANO MEGACOAT Carbide MEGACOAT CBN CBN PCD TN620 TN90 PR1535 PR1225 PR1215 GW15 KBN05M KBN570 KPD001 Carbon Steel GM GL CM PH GS 80 20 100 220 0 0 0 8 0 0 8 100 200 Coolant Alloy Steel O o 80 00 70 80 70 80 0 8 8 Stainless Steel 0 5 CD 0 5 CD 0 k w CD Cast Iron 100-200 Aluminum Alloys GS NB - 0 0 0 2 150 000 Brass - O o 0 0 3 0 2 Hard materials NB 0 5 8 Sintered Steel - 100-250 - Recommended Cutting Conditions Рекомендованные режимы резания на станках (Feed Rate / ap) : 1st Recommendation : 2nd Recommendation Workpiece material: S50C CD cc £ CL O Grooving W H In the graph below indicates the most recommended value of feed (f) Turning W 0 CA o ur 0 n 0 G G Feed Rate f (mm/rev) Feed Rate f (mm/rev) o 0 0 G 4.0 3.0 O. 2.0 1.0 W=6mm W=5mm X. W=4mm W=3mm W mNOl t Feed Rate f (mm/rev) 0.1 0.2 0.3 Feed Rate f (mm/rev) 0.4 o (3 4 2 2 1.0 2 mm width is not recommended T 3- 4 m i 1 1 1 1 U L 0.1 0.2 0.3 Feed Rate f (mm/rev) 0.1 0.2 0.3 Feed Rate f (mm/rev) 0.4 g in cp o O o 0) CT T3 0.1 0.2 0.3 Feed Rate f (mm/rev) 0.2 0.3 0.4 Feed Rate f (mm/rev) Note) 1. The above values are based on the condition that the dimension T of toolholder is 17 mm or less. 2. If the toolholder is not for the 8mm width insert and its dimension T is over 17mm, set the values for turning to less than 90% of those above. G29 Grooving