220 Каталог KYOCERA 2016 Металлорежущий инструмент для токарной обработки на станках Стр.E16

Каталог KYOCERA 2016 Токарные резцы с пластинами Стр. E16 0220 ENG Lab2u

SMALL TOOLS EXTERNAL INSERTS FOR KTKF TOOLHOLDER TKF-AS Inserts The KTKF toolholder can be used as multi-functional tooling for non-ferrous and non-metal when combined with a TKF-AS insert. (See Fig. 1) Applicable Inserts C32 Inserts (Photo Shows Right-hand) SJ_ Right-hand Shown D Turning / Grooving Insert hand: L-hand / PCD edge hand: R-hand ta Grooving Inserts (Turning possible) Right-hand Shown Part Number TKF12r/l 200-AS 250-AS TKF16r/l 250-AS TKF12L 200-ASR 250-ASR TKF16L 250-ASR TKF12"/l 150-NB 200-NB 250-NB 250-NB4.5 Applicable Toolholder E12 Recommended Cutting Conditions ; E47 Example of Spool Cutting Example of the pass of KTKF toolholder + TKF-AS insert Applicable Range TKF12-AS/-ASR 0.24. 0.20- 0.16- d O 0.12 -d 0.004 f(ipr) PCD inserts are for traversing and grooving. Cut-off is not recommended with these inserts. Insert Identification System TKF 12 R 200 - AS TKF 12 L 200 - AS Insert Type Width (Edge Width) TKF16-AS/-ASR 0.24-. 0.20- r\ £ 0.16- d O 0.12 -d 0.08- 0.04- K i 0.004 O.Oi f(ipr) 08 PCD Insert Hand Insert Hand Name of Chipbreaker R Right-hand AS AS Chipbreaker L: Left-hand NB: Without Chipbreaker Without Indication: The edge hand is same as the insert hand. R: Right-hand Note 1) When using TKF-AS/-ASR insert with KTKF toolholder, the edge position is 1.0mm below the center. (See Fig.2) Please adjust the edge height at the parameter of the NO lathe or using soleplates. 2) When the edge height can not be adjusted, please use TKF-NB insert. (Fig.3) KTKF Toolholder - I r I i Fig.2 When TKF-AS/-ASR installed (the edge position: 1.0mm below the center) KTKF Toolholder - Fig.3 When TKF-NB installed E16 Kyocera