249 Каталог KYOCERA 2016 Фрезы со сменными режущими пластинами для металлообработки Стр.J27

Каталог KYOCERA 2016 Инструмент фрезерный с СРП по металлу Стр. J27 0249 ENG Lab2u

MRP Guide for Drilling Drilling Depth Refer to Max. Cutting Depth ( Pd ) value in Toolholder Dimension table on page J22-J23. Traversing After Drilling Caution when Traversing right after Drilling Reduce the table feed by 50% of the recommended conditions until the center core part is completely cut off. The internal cutting edge's radial rake angle is large in the negative direction ( > Min cutting length ( L) for flat bottom face in table below. Insert Part Number L (mm) RDMT08T2M0-H 0D-7 RPMT10T3M0 0D-9 RPMT1204M0 0D-11 RPMT1204M0-H RPMT1606M0-H 0D-15 Guide for Ramping Ramping angle should be under a Max. (maximum ramping angle) in table below Feed rate should be under 70% of the cutting conditions on page J24 Part Number a Max. (°) tan a Max. MRP 012-S16-08 -160) Ramping is not available 016-S16-08 -160) 4° 0.070 020-S20-08(-180) 14° 0.249 MRP 025-S25-10-3T(-180) 14° 0.249 032-S32-10-4T(-200) 8° 0.141 MRP 032-S25-12(-300) 15° 0.268 040-S32-12 -300) 10° 0.176 040-S32-12-4T 200) 9° 0.158 050-S42-12(-300) 7° 0.123 MRP 040-S32-16 -300) 20° 0.364 050-S42-16 -300) 13° 0.231 063-S42-16(-300) 8° 0.141 MRP 050R-10-6T 4° 0.070 063R-10-7T 3° 0.052 MRP 050R-12 7° 0.123 063R-12 5° 0.087 080R-12 3° 0.052 080R-12-7T 3° 0.052 MRP 080R-16 6° 0.105 100R-16 4° 0.070 1 00R-16-7T 3° 0.052 125R-16 3° 0.052 1 25R-16-8T 2° 0.035 MRP 080R-20 8° 0.141 1 00R-20 6° 0.105 Formula for Max. Cutting Length “L” at Max. Ramping Angle L= DOC- tan a Max. Above is the value considering the clearance 1mm between the tool body and the workpiece. Kyocera J27 GRADES LINEUP/INSERTS 45a/70°LEAD 75° LEAD 90° LEAD HIGH FEED MULTI-FUNCTION SLOTMILLS RADIUS/BALL-NOSE OTHER APPUCATIONS TOOLHOLDING SPAREPARTS TECHNICAL INDEX