1078 Каталог KORLOY 2016 Металлорежущий инструмент и станочная оснастка ENG Стр.L11

Каталог KORLOY 2016 Инструмент и оснастка Стр. L11 1078 ENG Lab2u

General Information I Chip Breakers for Stainless steel machining HA / Finishing Sharp edge for shallow depth cutting Increase tool life through reduced chip control friction at high speed cutting Good surface finish of work piece HS / Medium cutting Enhanced cutting efficiency and increase tool life due to enhanced chip flow. Reinforced wear resistance through adopting a high land rake angle. Special land design to prevent notching and enhance toughness GS / Medium to Rough cutting Superior tool life at light intermittent cutting Better chip flow through wide chip pocket Prevent build-up-edge by low cutting force design VM / Roughing Chip breaker for intermittent cutting Unique chip breaker design provide smooth chip control. Strong edge line permit superior toughness 0 0.1 0.2 0.3 0.4 0.5 0.6 fn (mm/rev) Grades for Stainless steel machining KORLOY New Grades for Stainless steel machinig NC9020, For high speed turning of Stainless steel. Specially designed substrate & film suitable for high-speed machining of stainless steels. Superior cutting performance under conditions in moderate-speed applications for cutting low-carbon steels and low-carbon alloy steel Longer tool-life can be achieved thanks to a superior chipping-resistance design in the grade. Obtain better cutting performance. Korloy offers a variety of combinations of chip breakers to machine easily even in deeper depth of cut. PC9030, for medium to low speed turning of Stainless steel. By using an ultra fine carbide substrate, the PC9030 has a tougher substrate for moderate speed machining and intermittent cutting of Stainless steel A PVD coating is applied to this grade to enhance chipping-resistance and adhesion-resistance during machining of difficult-to-cut material Exclusive grade for stainless steel, using tougher carbide as a substrate and a PVD coated, this gives the insert superior lubrication properties. Enhance your surface finish and reduce burrs by utilizing our chip-breakers, exclusively made for Stainless steels. PC9530, for medium to low speed milling of Stainless steel. Tough ultra-fine carbide substrate primarily used for roughing and/or intermittent milling applications in stainless steel A PVD coating is applied to achieve better tool life in stainless steel and Ni-Cr steel applications. To reduce chipping in the cutting edge Korloy uses a tough carbide substrate and PVD coating to help prevent material build up around the cutting edges. Technical Information 11