468 Каталог ISCAR 2017 Токарный металлорежущий инструмент и инструментальная оснастка Стр.464

Каталог ISCAR 2017 Токарный инструмент и оснастка Стр. 464 0468 ENG Lab2u

FACE GROOVING USER GUIDE HELiMCE Clamping the Insert Clamping an insert correctly into the holder is necessary for stable machining. Be sure that the seat is clean of dirt and swarf. At the first stage of clamping, ease the insert gently into place. Make sure that the prismatic surfaces match. Screw Clamping Torque Insert Width Nxm 3 4-5 4 5-6 5 6-7 6/8 7-9 CGFG 51... 4-6 grooving and face turning both toward and away from center, with excellent chip formation. HELIFACE HFPR/L HGPL Type For general use in turning grooving on all types of materials. Use for deep grooving in low-to-medium feeds 0.04-0.15 mm/rev. Min grooving dia. 12 mm. HELI-GRIP GRIP...Y Type The “all in one” insert for parting, external grooving and turning, internal grooving and turning, face grooving and turning. DO-GRIP DGN... C Type For grooving operations only. Strong cutting edge for hard materials and tough applications in feeds 0.1-0.2 mm/rev. DO-GRIP DGN...J Type For grooving operations only. Positive rake, for soft materials in low-to-medium feeds 0.05-0.15 mm/rev. Face Machining Guide Tool Selection - Follow these recommendations to choose the right tool for high peformance t W J Choose the widest possible insert and tool, according to the cutting width and geometry to be machined. according to the maximum depth required. Choose the tool range with the largest diameter, depending on the initial grooving diameter required in the application. Remark: On integral shank tools the given range refers to the holder capacity. Tool Adjustment - Prior to machining, check and adjust the following tool positions. in light turning down to center and check for burr. surface. Correct position can guarantee good surface quality when face turning in both directions. 464 ISCAR