1076 Каталог FACOM 2013 Профессиональный ручной инструмент и оборудование Стр.1050

Каталог FACOM 2013 Инструмент Оборудование Стр. 1050 1076 ENG Lab2u

Personal safety Wear eye protection especially when cutting wire and fitting circlips or rivets. Sheathed handles are not insulating. Only 1000V tools are designed for working with live components. Correct tool selection Keep within cutter capacity (wire diameter and hardness). Do not modify or heat tips as this will impair performance. Cut at right angles and avoid twisting the wire. Use the throat rather than the tip of cutting edges. When fitting circlips use a tool within the correct range and only compress or expand the clip just enough. Lock-grip pliers should not be used as a permanent clamp. Components can move due to vibration or shock. Never modify the shape of a tool. Always use a 1000V insulated tool when working with live components. HAMMERS IMPACT TOOLS Personal safety Wear gloves and eye protection. Avoid striking equally hard surfaces. Do not use a hammer on surfaces exceeding 46 HRc. Use a mallet instead. Do not use suspect tools such as hammers with chipped heads insecure or cracked handles excessively mushroomed chisels or punch ends. Check handle fit before use. Hammering may generate sparks. Do not use hammers in a fire-risk area. Correct tool selection Rule of thumb hammer head should have a diameter about 10 mm larger than the surface to be struck. Avoid hitting with the edge of the hammer. Select chisels and punches fitted with a guard for increased safety and comfort. Do not use punches for leverage. Select tools with a guard. Never use tools with ill-fitting or damaged handles. Neverhard on hard. 1 Check tool condition before use. SAWING CUTTING DRILLING Watch out for chips Wear eye protection and gloves when sawing cutting or drilling and when handling sheet metal or metal objects while machining. Keep hands away from the cutting path. Metal shears are designed for cutting sheet metal not for wire. Keep within capacities. PRESSES AND BAR CLAMPES p. 734 Remain within capacity Presses and bar clamps are not designed for permanent clamping and should never be used to construct a guard rail or platform. Avoid using bar clamps to hold assemblies subject to vibration or shock as the joint could work loose. Do not use these tools for lifting. Always check before use and keep within clamping capacity (do not use extensions orimpact tools). Dontcut wire with metal shears Never erect guard rails or platforms using clamps. Dont use an extension for tightening. VICES Personal safety Fit the vice securely to a suitably sized support. Never use an extension or a hammerto tighten a vice. Avoid clamping hard towards the end of the jaws. Do not use the jaws as an anvil. Never repair or modify a vice. Always wear eye protection and gloves when grinding sawing drilling and hammering. Correct tool selection Select a swivel-base vice so that you approach the workpiece from the best angle. Fix vice securely to bench. Dont use a hammeror extension to increase pressure. 1050 Facom SAFETY RECOMMENDATIONS PLIERS p. 466