874 Каталог FACOM 2005 Профессиональный ручной инструмент для предприятий Стр.875

Каталог FACOM 2005 Профессиональный ручной инструмент Стр. 875 0874 ENG Lab2u

TORQUE CONTROL see page 234 SENSIBLE PRECAUTIONS FOR PRECISION TOOLS Avoid overloading by applying torques beyond rated capacity. Never fit an extension as this would modify lever ratios and give incorrect readings. Always store torque wrenches carefully after use. Torque wrenches are precision tools. Have yours checked regularly by Facom inspection facilities. Read operating instructions before use. Do not use impact drivers on torque multipliers. Always use a torque wrench. Careful storage and regular inspection by accredited Facom facilities. Never fit an extension to a torque wrench. PULLERS see page 4 78 PERSONAL SAFETY Wear gloves eye protection and safety shoes. Pullers generate several tonnes of force during use. Ensure correct positioning centred in line with the pulling axis and with good grip on each leg. Steady a puller where necessary to avoid rotation during tightening. Cover the assembly to contain components if the fitting splits suddenly or the puller slips. Do not stand in line with the puller and keep other people away. CORRECT TOOL SELECTION Never exceed puller capacity. Use a 3-leg puller rather than a 2-leg and select short legs. Always check tool condition before use and lubricate the screw. If a leg needs changing replace the complete set. Never modify or heat the legs as this will make them unsafe. Do not operate with an impact wrench. Use a mallet if the screw needs tapping to unstick a fitting. Do not use impact drivers on nut splitters. Always check that the pressure screw is properly centred and legs have secure purchase. Lubricate the screw regularly. Don't modify the legs of a puller as this will make it unsafe. PNEUMATIC TOOLS see page 508 PERSONAL SAFETY Wear gloves and eye protection. Wear a dust mask when sanding. For intensive use protect your hearing with ear muffs. Consider the safety of bystanders. SENSIBLE PRECAUTIONS Always disconnect tools before fitting drill bits grinding wheels or impact sockets. Keep within accessory rated diameters and speeds. Retain original guards (e.g. on grinding tools). On impact power wrenches use only impact sockets with appropriate locking pin and ring. Read operating instructions before use. Always wear appropriate protective gear. Always lock sockets to the machine. fd Always disconnect power tools before fitting accessories. FACOM PNEUMATIC TOOLS CONFORM TO CURRENT STANDARDS WORKING ON OR NEAR LIVE COMPONENTS see page 630 Only 1000V insulated tools protect from electrical hazards up to 1000V AC. Facom 1000V insulated tools conform to European standard EN 60900 and are individually tested and checked. Inspect your tool after each use. Discard if the insulation is damaged. Give yourself additional protection by using gloves mats and anti-UV goggles. 1000 V 1' 1000V insulated tools must be used when working near live components. Never use a tool with damaged insulation. ELECTRICAL AND ELECTRONIC ASSEMBLIES see pages 594-650 PERSONAL SAFETY Wear eye protection when there is a risk of flying debris e.g. for wire cutting stripping crimping or soldering. Choose wire strippers with offcut retainers. Never work with loaded capacitors or live components using antistatic tools (dissipating sheaths). CORRECT TOOL SELECTION Do not leave a hot soldering iron on fragile or inflammable surfaces. Always use a stand. Do not store a soldering iron while hot. Disconnect after use. Use ESD antistatic tools to IEC 61340-5-1 and IEC 61340-5-2 to protect sensitive electronic components. Select pliers with retainer to avoid flying offcuts. Always rest a hot soldering iron on its stand. catalogue FACOM F05 875