1061 Каталог MITSUBISHI 2020 Режущий инструмент Фрезы Резцы Сверла Пластины Стр.K029

Каталог MITSUBISHI 2020 Режущий инструмент для станков Стр. K029 1061 Lab2u

CARBIDE Shoulder milling (L/D=3) Other than the L/D = 3, use following recommended cutting conditions by multiplying the K003 page correction factor by overhang length. (mm) Work Material Depth of cut Heat resistant alloys lnconel718 Inclin an ation lie a<15" a>15” Depth of Cut ap Width of Cut ae Dia DC Radius of Ball Nose RE Cutt ng Speed (m/min) Revdution (min-1) FeedperTmitti (mm/t.) Feed rate (mm/min) Cutting SpEEd (m/min) Revolution (min-1) FEEd perTooth (mm/t.) Feed rate (mm/min) 10 5 60 1900 0.055 420 40 1300 0.035 180 0.5 1 12 6 60 1600 0.055 350 40 1100 0.035 150 0.6 1.2 16 8 60 1200 0.062 300 40 800 0.04 130 0.8 1.6 20 10 60 950 0.062 240 40 640 0.04 100 1 2 25 12.5 60 760 0.062 190 40 510 0.04 82 1.2 2.5 CC LlI a. Note 1) For stainless steel, titanium alloy and heat resistant alloy, the use of water-soluble coolant is effective. Note 2) If the depth ofcut is shallow, the revolution and feed rate can be increased, Note 3) The irregular helix flute end mill has a large effect on controlling vibration when compared to standard end mills. However, if the rigidity of the machine or the workpiece installation is poor, vibration or abnormal sound can occur. In this case, please reduce the revolution and feed rate proportionately, or set a lower depth of cut. Note 4) a is the inclination angle of the machined surface. I o 0 z 1 o 3 o DC a m K029