971 Каталог MITSUBISHI 2020 Режущий инструмент Фрезы Резцы Сверла Пластины Стр.J349

Каталог MITSUBISHI 2020 Режущий инструмент для станков Стр. J349 0971 Lab2u

CARBIDE RECOMMENDED CUTTING CONDITIONS Work Material Hardened steel (45 55HRC) AISI H13 Hardened steel (55 62HRC) AISI D2 Hardened steel (62 70HRC) AISI W1.AISI M2 Dia. DC (mm) Revolution (min'1) Feed rate (mm/min) Depth of cut (mm) Revolution (min'1) Feed rate (mm/min) Depth of cut (mm) Revolution (min'1) Feed rate (mm/min) Depth of cut (mm) 10 12 16 20 25 40000 40000 32000 24000 16000 12000 9600 8000 6000 4800 3800 1200 2000 3800 4400 5800 5800 5800 4800 3600 2900 2300 0.05 0.1 0.2 0.2 0.3 0.4 0.5 0.6 0.8 1.0 1.0 40000 24000 16000 12000 8000 6000 4800 4000 3000 2400 1900 800 1000 1900 2200 2900 2900 2900 2400 1800 1400 1100 0.03 0.05 0.1 0.1 0.2 0.2 0.3 0.3 0.5 0.5 0.5 32000 16000 11000 8000 5300 4000 3200 2700 2000 1600 1300 500 600 1200 1300 1800 1800 1800 1500 1100 880 720 0.02 0.05 0.05 0.05 0.1 0.1 0.2 0.2 0.3 0.3 0.3 Depth of cut Please refer to the list above for depth of cut. 1.5DC f Please refer to the list above for depth of cut. 1.0DC DC: Dia. I Slot milling with small diameter tools Work Material Hardened steel (45 55HRC) AISI H13 Hardened steel (55 62HRC) AISI D2 Dia. Revolution Feed rate Depth of cut Revolution Feed rate Depth of cut DC (mm) (min'1) (mm/min) (mm) (min'1) (mm/min) (mm) 1 15000 300 0.1 9500 110 0.05 2 8000 320 0.2 4800 190 0.1 Depth of cut Please refer to the list above for depth of cut. DC:Dia. O in Note 1) If the depth of cut is shallow, the revolution and feed rate can be increased, Note 2) If the rigidity of the machine or the work materials installation is very low, or chattering and noise are generated, reduce the revolution and feed rate proportionately. J349 ROUGHING BARREL TAPER BALL SQUARE