787 Каталог MITSUBISHI 2020 Режущий инструмент Фрезы Резцы Сверла Пластины Стр.J165

Каталог MITSUBISHI 2020 Режущий инструмент для станков Стр. J165 0787 Lab2u

CARBIDE RECOMMENDED CUTTING CONDITIONS Work Alloy steel, Tool steel, Pre-hardened steel Hardened steel (45 55HRC) Hardened steel (55 62HRC) Material AISI H13, AISI W1-10, AISI P21 AISI H13 AISI D2 Dia. DC (mm) Revolution (min'1) Feed rate (mm/min) Depth of cut (mm) Revolution (min'1) Feed rate (mm/min) Depth of cut (mm) Revolution (min'1) Feed rate (mm/min) Depth of cut (mm) 1 40000 3000 0.06 32000 2400 0.06 16000 710 0.05 1.5 40000 4500 0.12 32000 3600 0.08 10600 650 0.08 2 30000 4500 0.18 24000 3600 0.10 8100 520 0.10 2.5 24000 3900 0.25 19000 3000 0.13 6400 450 0.13 3 20000 3500 0.30 16000 2700 0.15 5400 390 0.15 4 15000 3000 0.40 12000 2400 0.20 4000 450 0.20 5 12000 2400 0.50 9000 1800 0.25 3200 380 0.20 6 10000 2100 0.60 7000 1400 0.30 2700 320 0.20 8 8000 1500 0.80 5600 1100 0.40 2000 240 0.20 10 6400 1400 1.00 4500 950 0.50 1600 210 0.30 12 5400 1200 1.00 3800 860 0.50 1300 160 0.30 16 2400 550 3.00 1200 280 0.80 1000 130 0.30 20 1900 480 4.00 1000 240 1.00 800 100 0.30 Depth of cut Please refer to the list above for depth of cut. 1DC Please refer to the list above for depth of cut. DC: Dia. Note 1) If the depth of cut is shallow, the revolution and feed rate can be increased. Note 2) When drilling, please set the feed rate at 1/3 or below the values above. Note 3) If the rigidity of the machine or the work materials installation is very low, or chattering and noise are generated, reduce the revolution and feed rate proportionately. LU D o CO a LlI Q J165 ROUGHING BARREL TAPER RADIUS BALL