90 Каталог MITSUBISHI 2020 Режущий инструмент Фрезы Резцы Сверла Пластины Стр.A044

Каталог MITSUBISHI 2020 Режущий инструмент для станков Стр. A044 0090 Lab2u

TURNING INSERTS CLASSIFICATION NEGATIVE INSERTS WITH HOLE y Q. CL Breaker Name and Picture Features Cross Section Geometry First recommendation for light cutting of stainless steel Stable chip control at light cutting range. Breaker with high rake angle provides excellent burr control. Stainless Steel 4 E 3 - 2 0 0.1 0.3 0.5 f (mm/rev) CNMG120408-LM First recommendation for light cutting of cast iron Narrow positive land provides low cutting resistance and excellent finish. Cast Iron 4 "E 3 -5 2 ra 1 0 0.1 I I I 0.3 0.5 f (mm/rev) CNMG120408-LK First recommendation for light cutting of difficult-to-cut materials Alternative chipbreaker for light cutting of stainless steel Enhanced chip disposal for depth of cut smaller than the corner R. Heat Resistant Alloy 4 E 3 2 ny 0.4 mm Corner ra 1 0 0.1 a u.4 mm Flank 0.3 0.5 f (mm/rev) CNMG120408-LS Alternative chipbreaker for light cutting of carbon steel and alloy steel Can be used at low depth of cuts and high feed rates. The curved edge allows smooth chip discharge. Recommended for workpieces in the 160 250HB range. Carbon Steel Alloy Steel 4 E 3 - 2 0 0.1 0.3 0.5 f (mm/rev) CNMG120408-SH O .C O) M Alternative chipbreaker for light cutting of carbon steel and alloy steel Superior chip control at small depth of cuts. Covers copying and back turning with wavy edge. Recommended for workpieces in the 200 300HB range. Carbon Steel Alloy Steel 4 1 3 - 2 25" r>-J.3 mm Corner 0 0.1 0.3 0.5 f (mm/rev) CNMG120408-SA sw Wiper insert for light cutting of carbon steel, alloy steel, stainless steel and cast iron in comparison to conventional chip breakers, the surface finish is maintained even If the feed per revolution Is doubled. Wiper design for increased productivity and improved surface finish. Carbon Steel Alloy Steel 4 E 3 - 2 0 0.1 0.3 0.5 f (mm/rev) CNMG120408-SW First recommendation for light cutting of mild steel Effectively controls adhesive chips. Suitable for mild steel light cutting. Mild Steel 4 E 3 S2 0 1 0 o.i h r 0.3 0.5 f (mm/rev) CNMG120408-SY Alternative chipbreaker for light cutting of carbon steel and alloy steel Suitable for light cutting. The curved edge allows smooth chip discharge. Carbon Steel Alloy Steel 4 I £ 3 6 2 Corner 0 0.1 0.3 0.5 f (mm/rev) CNMG120408-C Alternative chip breaker for light cutting of difficult-to-cut materials Ideal for heat-resistant alloy and titanium alloy. The sharp edge produces a good surface finish. The curved edge allows smooth chip discharge. Excellent notch wear resistance for light to medium cutting. ifficult-to-Cut Materials j CL CO 1 I \ I 1 0.1 0.3 0.5 CNMG120408-MJ A044