Токарные канавочные резцы Mitsubishi для наружного и внутреннего точения GROOVING

Токарные канавочные резцы Mitsubishi для наружного и внутреннего точения GROOVING

Токарные канавочные резцы Mitsubishi для наружного и внутреннего точения GROOVING _ Notes when wide face grooving by combination of plunging and traverse machining (2) When infeed machining at the bottom of a deep groove, chips may interfere on the cutting edge near the centre wall. In such cases, stop infeed machining just before the centre wall (at a point less than the insert width) then remove the remaining material by plunging. Notes when copying (BM Breaker) i With the BM breaker insert, 3 dimensional copying is possible. Set the depth of cut (APMX 2) to 30% less than the insert width. Finishing (1) When finish cutting, machine continuously from the outer wall to the bottom of the groove, then finally plunge cut the centre wall. Finishing (2) (BM Breaker) W m Si m m Carry out finishing in one process. For the depth of cut (APMX 2) when back turning, refer to the table on the right. Insert APMX 2 (mm) GY2M0200D100N-BM 0.10 GY2M0250E125N-BM GY2M0300F150N-BM GY2M0318F159N-BM GY2M0400G200N-BM 0.15 GY2M0475H238N-BM 0.20 GY2M0500H250N-BM GY2M0600J300N-BM 0.25 GY2M0635J318N-BM Mitsubishi Materials 553 GROOVING