380 Каталог MAHR 2007 Линейно-угловые средства измерений Измерительный инструмент Стр.13-18

Каталог MAHR 2007 Линейно-угловые средства измерений Стр. 13-18 0380 ENG Lab2u

MarGage. Standards Gages and Gage Blocks Thread Gages Checking Plug Gages 705 708 N 708 G Thread Limit Plug Gage 705 Special wear-resistant gage steel. Hardened and ground GO end with full thread profile pitch diameter corresponds to minimum permissible dimension of internal thread NO-GO end has only 3 threads and a shortened flank profile pitch diameter corresponds to maximum permissible dimension of internal thread Accuracy for metric ISO threads according to DIN ISO 1502 (up to 40 mm the GO end and NO-GO end are on a common handle. Over 40 mm the GO NO-GO end are on separate handles for easier handling) Nominal diameter 1 - 100 mm. For all standard and special threads Thread Ring Gages Special wear-resistant gage steel. Hardened and ground Accuracy of metric ISO threads according to DIN ISO 1502 Nominal diameter 1 - 200 mm For all standard and special threads GO Thread Ring Gage 708 G With full thread profile. Pitch diameter corresponds to the maximum permissible dimension of an external thread. The external diameter is relieved NO-GO Thread Ring Gage 708 N With reduced thread profile. For checking minimum permissible dimension of pitch diameter on external thread Master Thread Plug Gages Special wear-resistant gage steel. Hardened and lapped. Accuracy for metric ISO thread DIN ISO 1502. Other threads are in accordance to the respective standards Diameter 1 - 200 mm Available for all standard and special threads Go Thread Checking Gage 715 G Counter Plug Gage for GO Thread Ring Gage Go Thread Checking Gage 715 N Counter Plug Gage for NO-GO Thread Ring Gage With full thread profile and outside diameter with maximum dimension of external thread. Plug Gage must screw easily into Ring Gage Wear Testing Plug Gage 716 G For GO Thread Ring Gage Wear Testing Plug Gage 716 N For NO-GO Thread Ring Gage Three threads with considerably shortened flanks. Must not screw in more than one turn