Концевые фрезы Mitsubishi по металлу со сменными режущими твердосплавными головками CARBIDE INDEXABLE HEAD END MILLS

Концевые фрезы Mitsubishi по металлу со сменными режущими твердосплавными головками CARBIDE INDEXABLE HEAD END MILLS

Концевые фрезы Mitsubishi по металлу со сменными режущими твердосплавными головками CARBIDE INDEXABLE HEAD END MILLS _ HOW TO INSTALL THE HEAD Before installing remove all the dust and oil etc. Remove also the anti-rust oil from a new head. Coat only the screw part of the head with a small amount of anti-seize compound. If too much compound is used, during tightening, the anti-seize compound may enter the taper part and have a large effect on the coupling mechanism. Wipe off the anti-seize compound and make adjustments. Be careful that there is no anti-seize compound sticking inside the taper when inserting the head into the holder. Wipe off oil and dust. anti-seize compound (only screw part) Be careful because you may cut your hand if you touch the edge of the blade directly when tightening. There is still a clearance in this state, use the accessory wrench to tighten until the face of the head and holder fit snugly together. Refer to the table below for the necessary recommended torque angle. If regulating more strictly, use the torque wrench to tighten by the recommended torque below. Clearance V t II >> No clearance Fastening size Reference tightening angle a Recommended clamping torque (Nm) iMX10 50° 10 iMX12 o O LO 15 iMX16 50° 30 iMX20 40° 50 iMX25 0 LO CO 75 Note 1) Do not handle cutting edges with bare hands. Note 2) Please use the wrench provided. It is thinner than a standard wrench to prevent damage to the flutes when tightening. Mitsubishi Materials 1281 SOLID END MILLS